MarKuP: Apps, Graphics & Video
Try This

Platter: marked up content.

Part of 'Technics SL-10 Deconstruction'... View Project

   

Mark Up 1 to 5 of 5

  • Screw Caps (four)
    Once you have removed the platter, prise off the rubber caps with a screwdriver to then unscrew the platter support base.
  • The Platter Bearing
    This shows the bearing after the captive nut has been removed ...
  • Platter Bearing Nutt
    Unscrew the bearing nutt that fixes the bearing in place.
  • Bearing 'Film'
    There is a transparent 'film" that you might miss that you need to remove to access the screw lift holes.
  • Lid Screw for lifting platter
    Use two of the longer screws from the lid removed earlier to act as platter "lifts" to protect the bearing when lifting off.

Screw Caps (four)

Once you have removed the platter, prise off the rubber caps with a screwdriver to then unscrew the platter support base.

The Platter Bearing

This shows the bearing after the captive nut has been removed ...

Platter Bearing Nutt

Unscrew the bearing nutt that fixes the bearing in place.

Bearing 'Film'

There is a transparent 'film" that you might miss that you need to remove to access the screw lift holes.

Lid Screw for lifting platter

Use two of the longer screws from the lid removed earlier to act as platter "lifts" to protect the bearing when lifting off.

Chapters:

thumb
Technics SL-10 Working
thumb
Opened
thumb
Lid Panel
thumb
Arm Motor, Circuit Board and Arm
thumb
Arm Cord
thumb
Tonearm Underneath
thumb
Tonearm Top
thumb
Tonearm Schematic
thumb
Platter
thumb
Bearing
thumb
Motor
thumb
Motor and Circuitboard
Latest update: 09.02.2018 - Thank you all "feedbackers"...

All Comments & Questions about Technics SL-10 Deconstruction

  • Simon Meneely 12/12/2016 20:04:51

    test comment

    test general comment